Recent content by arceki

If I could know the viscosity measuring it by myself I would have done it, so that means, that I cannot measure it by myself, therefore I'm asking for it. Anyway thank you very much for giving an answer.

If I could know the viscosity measuring it by myself I would have done it, so that means, that I cannot measure it by myself, therefore I'm asking for it. Anyway thank you very much for giving an answer.

Hello everyone¡¡ I'm looking for a 33% solution of milk powder in water viscosity. Can anyone help me? Thanks in advance

Hello everyone, I've looking for Starch viscoty 33% solution in water, and didn't find anything, could anyone help me? Thanks in advance

Good Morning. I want to design a CIP system and I'm searching concentration and temperature values for alkali and acidic detergents. The CIP system would be used to clean an instalation where baby food is made so I suppose that the soil would be organic-type. I found some values for alkali...

I did but didn't find anything. I know the industry uses a lot of sulphuric acid, but here only NaOH is used http://www.sniace.com/seccion2.php?id=69&area=2 , anyway I've already found corrosion rate values of 304L in sulphuric acid. Thanks for the help

It depends on what you want. Do you have a mathematical model to solve the problem? If you do, I would use aspen custom modeler, or if the mathematical model is no very complex, you could use polymath. I've use aspen custom modeler and it worked perfectly well. Hope I helped

Hello everyone. I'm looking for corrosion rate of stainless steel 304L, used to storage viscose rayon at 35ºC. Instead I've been looking for corrosion rate of 304L in NaOH. But I think that at pH=14 corrosion rate is practically equal to zero, isn't it? Thanks in advance.

Ok thank you all.

Thanks micalbrch¡¡¡¡¡¡ it was useful, and thanks for answering so quickly¡¡¡ :D

I'm looking for some values for corrosion rate of ammonia in contact with some stainless steels 304-(L),316-(L). And carbon steel, I've looking very hard but I could't find anything just for 316 and carbon steel 1020. Thanks in advance.

Thanks¡¡¡, I'll have what you two said in mind.

Good Morning. Can dupplex stainless steel Gr.5A and 254SMO(CK3MCuN) be welded in seawater condition?. I think there's no problem with galvanic corrosion, since they have nearly the same corrosion potential, but I need to be sure, if anyone could help..... Thanks in advance¡¡