Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations IRstuff on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by ap91

  1. ap91

    Standardizing Thread

    Thank you.
  2. ap91

    Standardizing Thread

    Hello Friends, I need standardize the thread for which I measured outer diameter of thread and Thread per inch which comes out to be 0.305in and 20TPI. Now I cant see this combination on thread standard table. I dont known where I go wrong. Need some guideline. Thank you
See more

Part and Inventory Search

Back
Top Bottom