Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by antera

  1. antera

    Unit cell stress analysis

    Hey Matthew, Thanks for answering! The model is actually not a cube but a unit cell of a much larger model. The actual model is much too large to analyze in Pro/M, so I had to create that cell. The reason why I apply 6 symmetry boundaries was because the cell is symmetric in all 6...
  2. antera

    Unit cell stress analysis

    Hello, I'm new to Pro/M and this forum so please point out any mistakes I'm making. The problem I'm having is in using Pro/M to analyze stress on a unit cell of a plate heat exchanger. My boss suggested imposing flat rigid symmetry boundaries on 6 faces of the unit cell then moving each...
See more

Part and Inventory Search

Back
Top Bottom