Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations IRstuff on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by Anilkuber

  1. Anilkuber

    Link between analysis result values and expression

    I want to show location of COG tuning wheel (Flywheel) along rotational axis on drawing. Therefore it is necessary to have associative point or sketch which changes as per changes in model.
  2. Anilkuber

    Link between analysis result values and expression

    Oopps It dosen't work. But this solution is helpful in some cases. Thanks again.
  3. Anilkuber

    Link between analysis result values and expression

    Thanks Cowski, I tried it and it is working. But I am checking that position of that changes or not after modification in model. Thanks.
  4. Anilkuber

    flat and unflat part in single view

    hi Amya, Please try below procedure,(Actually I am using NX7.5,but u try in NX9) Start>All aplications>sheet metal>forming /Flattenin>Tools>Flat pattern>Select reference face for flat pattern. After above process your model remain same but u get flat pattern of your model which can be used in...
  5. Anilkuber

    Link between analysis result values and expression

    NX7.5
  6. Anilkuber

    Link between analysis result values and expression

    Hi, Please help me to use Values displayed after Analysis>Measure body command. Actually in one of my task I have to use centroid value along Z axis displayed in Analysis result window for expression given in sketch. Is it possible to do so. Best regards, Anil Kuber
See more

Part and Inventory Search

Back
Top Bottom