Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by angleburt

  1. angleburt

    Start-up of a Consulting Business

    desnov74, Thanks for the reply- I am going to purchase the latest edition.
  2. angleburt

    Start-up of a Consulting Business

    Desnov74 - I just looked into the book that you recommended and it was published in 1986 - Do you feel that the material presented in this publication is still pertinent? Tim
  3. angleburt

    Budgeting for Solid Works

    Thanks - I currently use solid works on a daily basis - and to be honest, couldnt see doing custom design build assemblies with out it - CorBlimeyLimey - Thanks for the response! All of the mentioned issues above have been noticed, but we currently manage to get around the little issues - Tim
  4. angleburt

    Budgeting for Solid Works

    I am putting together a business plan and am looking for input on original purchase price and then cost of yearly maintenance for Solid Works (sheet metal required). I have searched this forum and found anywhere from 4k to 8k for initial purchase - I am assuming this is a one time fee and the...
  5. angleburt

    Class 1 - Div 1 Electrical Enclosure

    Thank you JLSeagull. I understand the implications of modifing an enclosure, I was just not sure about installing these components without a purge, but it sounds achievable provided the correct pieces and parts are selected (obviously not by me, but someone specializing in this area) Thanks again.
  6. angleburt

    Class 1 - Div 1 Electrical Enclosure

    I have a request to upgrade a standard controls enclosure to satisfy class 1 - Div 1 (actually it is for a project in India and their request is Gas Group IIA/B, Zone 1, T4, I interpret this to be class 1 - Div 1) In the past, we have used enclosures with a purge (z-purge specifically), but for...
  7. angleburt

    Planning to go out on my own

    Thanks for the input guys. I am going to take advantage and work to get my PE first. I think staying were I am may be the best thing for now. Angleburt
  8. angleburt

    Planning to go out on my own

    I could not do engineering work without a PE, even as an ME. Most of the work that I am currently doing could be labeled as turnkey design, with the deliverable being a tangible item. While we have a PE on staff, we have never stamped a drawing. It is very rare, but when the equipment requires...
  9. angleburt

    Planning to go out on my own

    This is my first post so I would like to say hello to everyone. I have been lurking for some time. I have been cautious about posting the following question. It is my intention to start my own engineering firm but I am looking for a reality check. I finished my associate’s degree in 2001 and...
See more

Part and Inventory Search

Back
Top