Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by Angle C

  1. Angle C

    Tapered Hex Pin Datum Setup

    Building upon what I learned from pmarc and others in thread1103-360909 relating to datum referencing tapered faces of a part, I attempted to construct the attached drawing. This is a tapered hex pin. I don't feel this drawing is adequately specified, and I have these following questions. 1.)...
  2. Angle C

    I'm having troubling constraining t

    I'm having troubling constraining this simple static analysis (see attached image). The sheet metal acting as a latch is fixed to ground (door assy) at one end, a force is applied downward in the middle bending the metal strip, and because of the lengthened path retracts the latch at the other...
See more

Part and Inventory Search

Back
Top