Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JStephen on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by andromeda3
-
NX 7.5 Polygon-shaped holes
Attached is the part file showing the body (cylinder), from which I have been able to (partially) subtract the polygon. Ultimately, I would like to make this body "porous" through the addition of these polygon parts. However, I am having trouble figuring out the most time efficient way to create...- andromeda3
- Post #3
- Forum: Siemens: UG/NX
-
NX 7.5 Polygon-shaped holes
I would appreciate any possible advice on the following issue: I am attempting to design an object in NX 7.5 containing polygon-shaped "holes" that span from the top to the bottom surface. I've tried defining a polygon, extruding it such that it is located in the appropriate spot, but I am...- andromeda3
- Thread
- Replies: 4
- Forum: Siemens: UG/NX
