Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by Amit1258
-
hole callout-NX
Hi, Because original thread is closed . So just added link for reference. Regards, Amit- Amit1258
- Post #3
- Forum: Siemens: UG/NX
-
hole callout-NX
thread561-404791 Hi all regarding this issue,Make sure you are making hole feature by using hole command only(...not by extrude or revolve) So you could be able to use hole-callout in radial dimension while drafting. Hope to clear this issue Feel free to ask query regards, Amit.- Amit1258
- Thread
- Replies: 2
- Forum: Siemens: UG/NX
