Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by amin89

  1. amin89

    Cannot run an analysis when changing section oreintation in SAP2000

    Hi There I am a new user of SAP2000. I am designing a cold formed steel truss and I ran it few times. It worked perfectly. However, when I activate the Extrude view, I realize the orientation of some channel sections are wrong. Therefore, I changed the orientation of the Channels by rotating...
See more

Part and Inventory Search

Back
Top Bottom