Recent content by Amar005

Thank you John. Actually I am developing some standard tables like hole chart, BOM etc.I want to lock the content of header row & header column.Then I want to use these tables as standard library.So that no one can change anything in header.Only I want to give the user access to variable values...

I want lock some rows & columns from my table in nx8.5.Can anyone suggest how we can do it in nx8.5. There is one option lock rows but it is not working.

Hi All, I have an BIW Assembly with door trim.I have created master section drawing in ug nx5. But after completion of drawing I am unable to find out links of every view or sheet. It is possible to find out links of the drawing and can we edit it? Please giude if anyone has an idea regarding...

Hello Everybody, We have completed our model.Now we want to check this model through DCS File Checker before sbmit it to GM. We have GM Toolkit. Can anyone help me out regarding how we can check our file throgh file organization? What steps we have to follow? Please find attached image for...

Thanks Jaydenn, It works for me. Thank you very much. Regards, Amar

Hi All, Good morning. Can anyone help me out related with part clean up issue? I have one part file.In this part file so much unused data like surfaces, points, lines in that file.I want to clean that data from file. These data I have used as a reference.Now this data dont have any link with...

Hello John, I have tried that but It didnt work. I am in moulded part validation . Thanks and regards, Amar Halake

Hello John, Thanks for quick turn around. After performing analysis when I press MB3, It didnt goback to normal shade. For direction change I have to move back and choose another direction. Thanks and regards, Amar Halake

Hello All, 1)When I perform draft analysis in UG NX5,the body shows color representation as per draft setting. But after competion of draft analysis when I close command window, the color representation remains as it is. If I want original color of the body back how to proceed? 2)Once I...

Hi, Thanks all. Have a nice day. Regards, Amar Halake

Hello John, By mistake I have put this into same thread. I have created new thread for this. Sorry for inconvience. Have a nice day. Regards, Amar Halake

Hello All, We have an assembly with 20 subassemblies and total 250 parts.We have to modify some parts. We are facing problems for searching particular part. Can anyone knows- How to perform part search in assembly navigator? Please suggest. Have a nice day. Regards, Amar Halake

Hello All, We have an assembly with 20 subassemblies and total 250 parts.We have to modify some parts. We are facing problems for searching particular part. Can anyone knows- How to perform part search in assembly navigator? Please suggest. Have a nice day. Regards, Amar Halake

Hello John, Thanks for quick reply. I have edited tolerance value then also it shows same error. Is there any EDGE specific tolerance value? Can we set the value before start of model or any customer default setting? Thanks Amar Halake

Hello All, When I perform the examine geometry analysis for the part it shows the error only in tolerance zone. I have created the part by using surfacing commands and then sew all surfaces. In modeling by default distance tolerance is .001. When I performed check it shows information as...