Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by am

  1. am

    "AISC Iron & Steel Beams, 1873 to 1952" - Available

    Your contributions for the last few years are of immense help to all of us. Congratulations.
  2. am

    Precast Pile Cap

    bridgebuster - thanks a lot for the information. I will study them now.
  3. am

    Precast Pile Cap

    Thank you all for your suggestions. I am not very keen to do this before getting a complete brief. My biggest concern is the connection, as kslee1000 has commented. Bridgebuster, any reference drawing will be very important for my design development and discussion. Please forward me the copy...
  4. am

    Precast Pile Cap

    In order to achieve shortest down time, project engineers are requesting to explore the possibility of installing precast pile cap on a group of piles. Pile cap size will be quite large - over all size may be 3m x 14m. I designed pile caps before but never used a precast pile cap. A...
  5. am

    Structural analysis of communications tower

    I had successfully used Microstran - MSTOWER program and Weisman - Guymast program in the recent past. I was associated with analysis and engineering of telecommunication structures for ten years.
  6. am

    Low heat cement in Machine Foundation

    hokie66, thank you for your response - this is what I am experiencing. Sorry, I could not respond earlier - my computer crashed! It is working now. Regards AM
  7. am

    Low heat cement in Machine Foundation

    It is quite common to have thick slab [800mm to 1200mm or more] foundation for heavy machines in minining sites. In such cases we should use low heat cement. Theoretically, special form work with heat insulators are required for such type of massive pours. I have not seen any low heat cement...
  8. am

    Structural Analysis Software Evaluation....

    I have been using SpaceGass and Microstran in Australia. They both have some limitations but quite brilliant for general structural analysis purposes. I have not used design module of SpaceGass and therefore can not comment. Steel Design module of Microstran is quite good and complies well...
  9. am

    Grout hole requirement

    Thanks DBD, no ill feelings. Cheers AM
  10. am

    Grout hole requirement

    Wopshistos Thank you very much. This is a valuable documentation. Regards AM
  11. am

    Grout hole requirement

    DBD Sorry, I could not get back to you earlier. In the mean time I noted that dbuzz has given some of his input and I was going to write the similar thing. To my understanding this forum is for sharing the vast knowledge of all the people who participate in discussions and we all mutually...
  12. am

    Grout hole requirement

    DBD Thank you for your comments. Personally I do not have any satisfactory input in this subject. I will run this discussion with my other industry colleagues/peers and will update on this subject if I get any feedback. Regards
  13. am

    Grout hole requirement

    Thank you all for your responses. It is interesting to know about the practice in the USA also. We will stick with the running practice of 300mm then.
  14. am

    Grout hole requirement

    dbuzz Thank you very much for your input. We do exactly the same thing as you explained. I am looking for any technical reference to justify this approach. Regards AM
  15. am

    Grout hole requirement

    We generally provide 14mmØ grout hole in a base plate when the base plate size gets bigger than 300mm. To my understanding, this comes from accepted industry practice. I am wondering, if there is any published document where I can find the proper recommendation on grout hole size and the...
See more

Part and Inventory Search

Back
Top