Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by allahmohammad
-
Weld & HAZ Hardness
A Krautkramer MIC 10 On Site Hardness Testing Device according to Ultrasonic Contact Imedance ASTM A 1038 was used to get the hardness values from the surface of the material.(the diamond indent in the material surface is electroncially measured. vickers penetration with indendation evaluation...- allahmohammad
- Post #7
- Forum: Material engineering general discussion
-
Weld & HAZ Hardness
It is right, In-situ hardness testing on service-exposed equipment is at best for qualitative purposes. With refrence to which values to be verified to check the in service obtained values are refering to what condition of the equipment?- allahmohammad
- Post #3
- Forum: Material engineering general discussion
-
Weld & HAZ Hardness
Reformed Gas TO Synthesis Gas Convertor Reactor - Shell Plate SA 516 Gr 55 Material - Weld Hardness 243 Brinells Hardness / HAZ 226 Brinells Hardness. ASME SEC II Part C (welding consumables)SFA 5.1 Specification for carbon steel electrodes for Shielded metal arc welding dosen't mention WELD &...- allahmohammad
- Thread
- Replies: 7
- Forum: Material engineering general discussion
