Because are still many company that used ± tolerances I have few questions regarding inspection of these according to ISO standards/independence principle.
I know that size dimension is the distance between two points, like a measurement done with a caliper.
The questions are:
1.How many...
See the attachement, I would like to know how to consider the real dimension of the rectangular part in worst case?
I don't know if in reality in worst case the part look like in case one or two?
Based on the discustion that we had I am 90% that the corect worst case is two so the dimension...
Back from vacation…
KENAT is referring to ISO 8015 from 1985,
but this is obsolete and replaced with a new version from 2011.
Any how the bought standards are saying the same think regarding independence principle.
I have a look over this standard/independence principle and, this makes me...
Hi desertfox,
I had the same opinion with you till few weeks ago when I started to play with CETOL6σ and
I saw that the parallelism is not consider for calculation of block width.
And I start to think that this might be true (CETOL6 σ approach)
because if the maximum width of the block would...
I have a rectangular block, with the width of 100+/-1 mm and one side face of the block is datum A
and the opposite face I have an tolerance frame that indicate parallelism with A within 0.2.
The question is which is the biggest width of the block 101,2 or 101?
Could anyone make reference to...
