Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by aliask
-
Bending 3/16" 6061 T6
I am wanting to put 2 small bends in my 3/16" 6061 T6 parts. They will be very small gradual bends on the ends to flare them up no more than an inch. My first question will this work with out cracking? If so, will they still hold there T6 condition after forming or will I have to reheat-treat...- aliask
- Thread
- Replies: 2
- Forum: Commercial product engineering general discussion
