Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by ali moghadam
-
What is the angle between plane of gear in solid modeling?
Hi dear I'm modeling dynamic simulation of two gear with each other in inventor software I assigned the center of distance of them but I don't know how I could define the angle between plane of each gear not to have clearance or interference in motion would you mind if any one guide me in this...- ali moghadam
- Thread
- Replies: 1
- Forum: Gear and Pulley engineering
