Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by ALEXciBROWN

  1. ALEXciBROWN

    Clamping and walking beam for automated wire bender

    So the part needs to constrain each loop I think because both ends of the part get another crimp/die process. We need to know where those ends are. If the wire isn't straightened correctly (which it likely won't be) then the part form will be very squirrely.
  2. ALEXciBROWN

    Clamping and walking beam for automated wire bender

    i forgot to mention there are 2 wires stacked on top of eachother
  3. ALEXciBROWN

    Clamping and walking beam for automated wire bender

    this is top view
  4. ALEXciBROWN

    Clamping and walking beam for automated wire bender

    I need tips on how to clamp this 1.08mm diam wire form. The internal bend radii is 1mm. The wire is coming off a coil from the left and straightened then bent one loop at a time. We need to maintain control of the wire at all times because it may "corkscrew" just based on the natural wire...
See more

Part and Inventory Search

Back
Top