>>What is the scientific name for rust or corrosion? How do you explain the delaminating of a steel beam that has been exposed to moisture. I need to talk to a group of kids about this, and I just don't want to say it rusted.
What about the term "oxidised". The terms of corroded and rusted...
The 2024 has a lower copper concentration than 2011 which may be impacting on the ability to bright dip. My investigation didn't look at which which process (bright dip or anodizing) the copper was etched from alloy being anodized. But from memory, the black precipitate did initially form during...
At last something on my thesis topic.
The quick reason why aluminum copper alloys are unsuitable for anodizing is that the copper is preferentially etched from the alloy during the anodizing process. If copper is in the grain boundaries, this etching will leave the structure weak and...
A quick google search would indicate that the Moos Hardness Scale the Russian equivalent to the Mohr's Hardness scale. It seems to have the same values for the same minerals.
I think you might mean Mohs hardness. It's a hardness scale used in the minerals field. Diamonds have a hardness of 10, Talc 1, and Quartz has a hardness of 7. Relatively, a pen knife will scratch anything up to 6.5 and a fingernail upto 2.5 on the scale.
There are various paints and gels that can be used to electrically isolate the two metals. The one I'm currently using is called Tef-gel and should be available world wide under that name. Another product is called duralic, it's a yellow zinc chromate paint, but it might be known under a...
It's gets a reasonable right up in my 1977 edition of the Sandvik Welding Handbook. In short, this new technology has been around for some time. It's applications are / were for precision welding situations, paarticularly in areas like electronics. At the time they thought it could take over...
From an old copy of "Definitions of Metallurgical Terms"
by the The Australian Institute of Metals - 1971.
Stress Relieving: Heating a metal to, and if necessary holding at, some temperature generally below the recrystallisation range, followed by uniform cooling, for the sole purpose of...
It depends on the type of stainless steel being used for races. Austenitic stainless steels (2** and 3**) won't magnetise, but ferritic stainless steels and martensitic stainless steels (groups 4** and 5**) are magnetic. Precipitation hardening stainless steels and duplex stainless steels need...
A third person showing showing caution.
Anchors designed for sand or mud bottoms require mass to allow the fluke of the anchor to dig into the bottom and a length of chain to make the pull on the anchor horizontal across the bottom, so if the anchor begins to drag it will hopefully catch again...
Fill the tube with dry sand and seal the ends before attempting to bend. The sand helps prevent the tube crushing or kinking, but because the sand is lose it still flows allowing the tube to bend.
Part of the problem with getting a good epoxy bond with aluminum is that the aluminum oxidizes almost immediately which means the bond isn't as good as it could be. With sailing equipment, we used to get this problem by using wetordry abrasive paper, but instead of using water as the wetting...
Don't underestimate the strength of paper mache'. Helmets made from paper mache' were used as hard hats by cavers and climbers before plastic ones were readily available.
For a one off shell, this may make you laugh, but make a mold of the shape you want and then make the shell out of paper mache'. It should end up lighter, just as strong and easier to build than the equivalent in fibreglass.
