Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by ala11553
-
CREEP ANALYSIS/ CLAD VESSEL/ CREEP RANGE
Dear all I'm new to this forum and looking for some advice regarding the CREEP of materials. I have a column with the following parameters Design Pressure= 50 barg; Design temperature= 425C; operating temperature= 380C; MOC= SA516 Gr.70+316L Clad; Design Code: ASME Sec.VIII, Div.1; Cyclic...- ala11553
- Thread
- Replies: 1
- Forum: Metal and Metallurgy engineering
