Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by akshehata

  1. akshehata

    Difference btwn NPSH and NPSHA

    BigInch, you were right V2/2g != 0 (not equal) since V=Q/A where Q is the flow rate and A is the Cross sectional area at pump inlet. Your reference point should always be the pump inlet where you measure the static & dynamic heads (i.e. the total head) as well as the vapour head. In most cases...
See more

Part and Inventory Search

Back
Top Bottom