Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by aknet98

  1. aknet98

    5052 Al retainer ring

    Do you have any suggested references to look at? Thanks
  2. aknet98

    6061 Al dish

    What if i can't spin it? (other reasons besides thickness) Is it feasible to stretch form it?
  3. aknet98

    5052 Al retainer ring

    I really have no experience in this area but I need to figure out a way to make retainer rings (basically its just a ring with not very tight tolerances, 90mm ID, 92 mm OD,1.6 mm thickness, and opening in ring of 1.75 mm.) I am probably going to use 5052 Al or a material similar to that and...
  4. aknet98

    6061 Al dish

    I am producing a dish of 1 m diameter and .25 m depth made out of 6061 Al. I thought of deep drawing but I am worried about puckering and the fact I only need a small quantity of these dishes? I am looking into pure stretch forming but I am not sure if this is feasible or not? Any suggestions...
See more

Part and Inventory Search

Back
Top Bottom