Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by ajn22

  1. ajn22

    Section View

    Do you know if that is explicitly called out in a standard?
  2. ajn22

    Section View

    If a spherical part is dimensioned in a section view, do these dimensions only apply at that particular section? For example, if one were to dimension a hollow sphere (OD – 50mm+/-1mm, ID – 45mm+/-1mm) in a cross section, would one check these dimensions at many cross sections or only the cross...
See more

Part and Inventory Search

Back
Top Bottom