Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by Ahnfeldt
-
Dialog boxes and coulmns resetting after restart of NX6
The "Save Dialog Box Settings Between sessions" was toggled ON. I tried to toggle it OFF, restart NX and then toggle it ON again, restart NX, but the problem is still there. Is there a way to see if NX is writing to the registry?- Ahnfeldt
- Post #5
- Forum: Siemens: UG/NX
-
Dialog boxes and coulmns resetting after restart of NX6
"As far as the Extrude dialog is concerned, at least in NX 6.0, the only settings which are retained between sessions are the numerical Values for the extents of the Extrude, but not the Start/End options nor the Boolean option or anything that deals with Draft or Offsetting." For me nothing is...- Ahnfeldt
- Post #3
- Forum: Siemens: UG/NX
-
Dialog boxes and coulmns resetting after restart of NX6
Hi I use NX6 and I have a problem with settings not being remembered between sessions. The settings that are not remembered are settings in dialog boxes (selection types in the extrude function for example) and columns in part navigator. Every time I start NX I have to rearrange the columns in...- Ahnfeldt
- Thread
- Replies: 5
- Forum: Siemens: UG/NX
