Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by Ahmed Agrody
-
Runout checks and limits
here is agitator drawingshttps://files.engineering.com/getfile.aspx?folder=29208057-4739-4e27-b428-6943cf941b3a&file=Shaft_Agitator_for_Neutralizer.pdf- Ahmed Agrody
- Post #4
- Forum: Drafting Standards, GD&T & Tolerance Analysis
-
Runout checks and limits
I edited the file name so it can be downloaded- Ahmed Agrody
- Post #3
- Forum: Drafting Standards, GD&T & Tolerance Analysis
-
Runout checks and limits
Dears Gents i have urgent question , i have agitator upper shaft [ OD is 160 mm , length is 2 m ] which is connected to hollow shaft gear reducer with torque arm and supported with self aligning roller bearings and connected to bottom shaft [5m] by coupling , currently we have excessive...- Ahmed Agrody
- Thread
- Replies: 3
- Forum: Drafting Standards, GD&T & Tolerance Analysis
