Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by Ahhthatlldo
-
Is it ok to say male and female parts?
Sorry I'm new here Didn't realise there was a thread for that, but thanks for the advice, and the person who I'll be submitting it too isn't particularly PC so i'm sure it will be fine thanks!- Ahhthatlldo
- Post #3
- Forum: ASME (mechanical) Code Issues
-
Is it ok to say male and female parts?
I might be being pedantic here but is it acceptable to refer too in reports Male and female parts? I.E. the Female part being a bearing and the male part being the lay-shaft that goes through it. Thanks for your help!- Ahhthatlldo
- Thread
- Replies: 9
- Forum: ASME (mechanical) Code Issues
