Recent content by aero101

thanks again everybody for your very valuable input, this was a great lesson for me CorBlimeyLimey - for reference i am attaching my unsuccesful miter flange attempt http://files.engineering.com/getfile.aspx?folder=72ebb7c5-ae45-4ac2-b3ea-1fd883c922d6&file=bend_relief_-_miter_flange.SLDPRT

MDGroup - thanks for the idea! What are the proper steps to do it right? I edited the sketch in base flange but I have a feeling it's not way to do it. CorBlimeyLimey - - I have tried that, but it wont let me unfold the miter flange. Thank you again

thank you all for your input, the shop has laser cutting abilities and wants to keep the relief as small as possible. I attached another pdf, I changed the approach a bit. I would like to have only a tear type relief approximately as shown with red lines but only am able to achieve whats on the...

I am designing sheet metal part, it has an internal cutout with .25 edge flange all around it. Is it ok to create my custom bend relief - picture attached - or should I stick to SW custom relief type in edge flange feature? Those look rather strange for this application and I like that my own...

meant 1/4 clearance hole, dont too much info about application at this point, but thanks for your input everybody

KENAT thanks for going back to this, just redrafting this drawing, got the screw information additionaly, is .285 hole acceptable?

thank you for your responses

this is for 1/4 28 socket button head cap screw

not sure if this is the correct forum to put this - is there a table referring to countersink dimensions? specifically I am after 90 deg countersink for 1/4. your tips will be greatly appreciated. thank you

or actually does not .567 +/-.01 imply that the tolerance is .55 to .57?

MintJulep This is what I would understand if the dim callout says .567+/- .010, but does .567 +/- .01 really imply .557 to .577 and not .55X o 57X?

but is there a point to have 567 ± .01?

currently not part of any company, so the best is to set up account with ASME or IHS? what is the cheapest way to go? thank you

Also wanted to ask -the ASME quote - does this need to be purchased or is it free info the ASME standars, thanks again

Hello Belanger, Thank you for the confirmation.