Try to save the drawing on a local disk and upload again. Or check your Internet, the issue may be caused by the network speed, sometimes network broke but connection will not stop immediately.
Do you mean you want to open drawing using 09 by double clicking the file? Firstly, right click a dwg and choose to Open with-> Choose program, and from the list of programs select 09, also tick "Always use selected program to open this kind of file."
However once you open the 06, the default...
http://www.autodwg.com/vectorNow.htm
A raster to vector converter that convert BMP, TIFF, GIF, JPG file into editable DWG/DXF file.
Hope this help you!
Hello Judge,
you can try the new release of the stand alone version of AutoDWG. It is now support raster to vector conversion including converting scanned PDF to editable vector DWG.
http://www.autodwg.com/pdf-to-dwg-converter/
Good luck!
"Judge (Mechanical) 22 Sep 06 22:23
I have alot of old 2D drawings on paper, which I am in the process of scanning & saving as pdf files. Is there any way to convert these scanned pdfs to dwg format? I have tried AutoDWG but it only works for original pdf files not scanned pdfs. Any suggestions...
Here is a detour:
To insert images on a single layer. Open properties->general, the color of the frame is set bylayer; open the layer manager and set the layer color to white or the same color as the image's border.
http://www.autodwg.com/DWG2Image/
here you have the right thing that you are looking for, this application convert drawings into bitmap with crystal clear quality, it is recommended to run the AutoDWG program and select GIF for the output file format, and 300DPI resolution, image looks great and...
Normally PDF files created with smaller or equal file size, but if it increases steep then there must be extensive x-referenced drawings associated with your "main" drawing, the drawing size to be converted should be main drawing plus x-ref drawings, if this is the case, there is no way to...
