Jerry create crossing centerlines though tube center in drawing. Then create sketch fillets at the intersections.
Then create your points by inferencing the straight centerlines.
If you need further clarification email me a adaniel65@earthlink.net
Regards,
Antonio
I've used AutoCad 2000, ProEngineer, and Solid Works. I must say that ProEngineer is a powerful program!
But if you have never used a 3D modeling program, I find that SolidWorks is easier and more logical than Pro-E.
Solidworks is windows based. ProEngineer is Unix based.
If you have been...
The Tick is correct. In SW you just delete the point.
Sorry, maybe too vague an explanation. The steps are: Feature Menu/Select feature/Right Click/Edit Definition.
The rest is pretty self explanatory. You can always use the help menu.
Good Luck.
I had this problem at one point while designing all day.
I found that if I lean forward in my chair it creates a lot of stress in my neck and shoulders.
I figured it out one day when I had a different chair that made me lay back in it and rest my head against the back of the seat.
Also, it...
