Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by aammons2

  1. aammons2

    GD&T question about concentric holes

    Okay, after making some revisions and correcting the tolerance issues here is what I have arrived at. Thanks for the pointers. I think this is much better. Any suggestions?
  2. aammons2

    GD&T question about concentric holes

    Hello, I was hoping to get some guidance with GD&T as this is my first crack at it out of school. This is a gage that will have a precision ground pin coming in from the top to check for a hole location in a cylindrical part w.r.t a dimple on the bottom side of that part. Hole and dimple are in...

Part and Inventory Search

Back
Top