Yeah I just figured it out. Normally in the config.pro file you select display ISO or ANSI standard which I played with with no effect. In the dimensions properties box, there is a check box for "Dispay ISO dimension," which fixed the display.
Before clicking the check box in my dim...
In Pro/E WF5 the limit tolerances showed in drawings as an over under limit. That is the high value on top of the low value. In Creo/Parametric the limit dimensions are now displaying as High-Low.
Is there a way to display them as it did before?
What are you using for the sweep? If you use a varriable section sweep you can set the section plane control to normal to a projection. This will limit the profile from moving in an additional axis, simulating a 3-axis machine.
If I am understanding you right though, it would seem like you...
Sounds like you should be using a different software package. Are your points from some sort of scan? You need some program that can mesh point files, like Geomagic. Pro/E was not designed to mesh point data.
If you want you are welcome to have the batch file I use. I put the batch file in each model folder, and when you run it it creates a sub folder called "old" and moves all but the current file into the "old" folder. It also goes through and deletes the log files and other scrap files.
Let me...
I don't know your intent, but from your pictures I would suggest you may be better off using the sheetmetal application. Create your part as a flat part with a simple linear disk pattern. Bend the part after you have it all set up. In addition to being the easiest way to do what you have...
Anyone know, if you have a maintenance agreement and a licence for Pro/E should you be licenced for Creo 1.0 Parametric?
I got an email from PTC marketing Creo stating that Creo 1.0 was now available for maintenance partners and it now shows up in my account's available downloads section. From...
dgallup is correct Enginerd,
The version you have is a re-branded version of WF5. It is the same build as WF5 but the title bar says CREO and you licence says CREO Pro/Elements. The actual revised software package doesn't come until this summer at the earliest.
I overall really like Pro/E or Creo or whatever you want to call it, but I agree that they have some issues they need to fix. A lot of the issues seem to be easy fixes, but for some reason PTC never seems to take care of them. I also don't like when the update half the features of the program...
