Hey Thanks guys for the feedback. The analysis was done in Single-Pass. I played around with the mesh density and found that it did level off. There were some anomalies due to the odd mounting as well as the weighted links. Since this was a ECM bracket that mounts to a large generator engine...
Hello,
I ran some model analysis on a bracket and used AutoGEM to generate the mesh. The results were as follows:
First run with AutoGEM – 67 hz, 94 hz, 114 hz, 146 hz for the 1st through the 4th modes respectively.
After changing the mesh to 1 cm max segment length, the modes increased for...
