Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by A7A

  1. A7A

    UMAT convergence problem

    Hi, I'm simulating the behavior of anisotropic material using a UMAT subroutine. The UMAT works fine when using single element. However, when I use multiple elements (C3D8R), I get convergence problems. The problem is as follows: The simulation stops suddenly with error 'Too many...
  2. A7A

    PERZYNA material model (ANSYS (APDL)) ?

    Hi, I'm trying to get the stress-strain data of a specific material, by simulating the viscoplastic behaviour using a rate dependent material model (PERZYNA), but the problem is that when using this model for high strain rate (100 [s^-1]), I get approximately the same yield stress !! (see the...
See more

Part and Inventory Search

Back
Top Bottom