Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by 310346

  1. 310346

    Engine dynomometers

    Having looked seriously into acquiring a Dyno and realizing that for $10/15.000 I would not get much except a very basic water brake. Needed something that can hold the load for long time, and the only ones are the Eddy Current Dyno’s. In view of that, contacted a North American company (Super...
  2. 310346

    Engine dynomometers

    Importing used machineries in to China under customs law is prohibited, imagine the headaches buying used stuff and doesn’t work or and sourcing parts. Regards
  3. 310346

    Engine dynomometers

    Oh, well thanks for your advice, looked at the company in NZ and they only make chassis Dyno’s, I need an engine Dyno. Regards
  4. 310346

    Engine dynomometers

    Hi Guys Need some help, we are involved into engines in China and normally we take the engines to Japan to have it Dyno, this has proven to be time consuming and now we are looking to get our own Dyno. I have been looking at what is available in North America, while not an expert, decided to ask...
  5. 310346

    cenrtifugal clutch

    Hi Mike Found more info please see here,same principle modified for a bigger engine, maybe you can decipher it now. I think the U shaped are wages and fly out thus depressing the pressure plate..? http://www.geareddrives.com/BW350%20Owners%20manual_11.2.2010.pdf Thanks 1946
  6. 310346

    cenrtifugal clutch

    Mike Thanks again, if this in not too much to ask could you please draw me a sketch to be able to understands this in a more objective way. I have done some drawings to your suggestions but it doesn’t make any sence to me. Respectfully 310346
  7. 310346

    cenrtifugal clutch

    Hello Mike Unfortunately don’t have any illustration or drawing other that what is on the webpage. Thinking he would not have invented this and spend over 3 days looking at all the inventions, but dint find nothing even similar excepts the ball bearings pressure plate. There is another link...
  8. 310346

    cenrtifugal clutch

    Thank you Mike , just have to work out how those fingers are able to look up the clutch plate. 310346
  9. 310346

    cenrtifugal clutch

    HI Guys, new here and hopefully I can get some answers. Bud Warren ( RIP) has developed a (http://www.geareddrives.com/PSRU_for_Subaru.htm) new type of centrifugal clutch/pressure plate, looking at the installation manual , I can’t see how is possible to look up the clutch by centrifugal motion...
See more

Part and Inventory Search

Back
Top