Recent content by 22854

ash9144 I am not used to abreviations or acronysms. Could you please tell me what do you mean when referring to PPE ? Than you very much for your help.

I have a rupture in 98% sulfuric acid line (carbon steel) and have to prepare it for repair and put it in service again. Which are the recommended procedures for cleaning the line before giving it to maintenance and the ones before introducing the product to avoid presence of moisture, etc.

I am very interested to know of different alternatives to for the recovery and reutilization of cooling water tower blowdown, instead of sending it as wastewater.- For any of the alternatives it will be of great help to know which are the processes required to treat this water for the proposed use.

Which are the problems associated to deminearlized water used as BFW (to produce HHP steam = 110 bar) with pH below 6.5 or above 7.5 ? Which are the main reasons to maintain it in the range 6.5 < pH < 7.5 ?

Dear Friends, Thank you all for your help and assesment. Regarding the limits of 100 ppm of sulfates going to the sea, by the time I asked my first question we sent a reclamation to the authorities to study and reestablish new limits for this and other parameteres of contaminants in the...

I'm interested to know opinions on which compressor type (alternative , centrifugal, ecc.) is mostly used or reccomended from different points of view (operational, maintenance, initial cost, ec.) nowadays.- Service is to compress low pressure (0,5/0,6 bar g) gaseous CO2 coming from MEA or MDEA...

I'm interested to know opinions on which compressor type (alternative , centrifugal, ecc.) is mostly used or reccomended from different points of view (operational, maintenance, initial cost, ec.) nowadays.- Service is to compress low pressure (0,5/0,6 bar g) gaseous CO2 coming from MEA or MDEA...

Thanks to all for this ample discussion. We studied the option to use HCL to regenerate IX resins but it is not a good option from the economical point of view and have also to change materials and increase storage capacities three times. The use of RO means that we will still have sulfates...

In fact the municipal regulation is related to the discharge to the sea. We have a limit of 100 mg/lt.- In general, individual effluents have the following concentrations: Neutralization basin from demin water plant: 4900 mg/lt discontinuous. NH3 system cooling water blowdown 825 mg/lt...

I would like to know which are the most used methods o technologies to eliminate or reduce sulfates contents from industrial waste water to comply with municipal regulations. Main quantities of sulfates come from neutralizing basin of demin water plant and cooling water tower blow down.

I would like to know which are the most used methods o technologies to eliminate or reduce sulfates contents from industrial waste water to comply with municipal regulations. Main quantities of sulfates come from neutralizing basin of demin water plant and cooling water tower blow down.

I work for an Ammonia & Urea producing plant. We are interested to increase our actual capacity of the urea plant. We have an excess of NH3 but need an extra amount of CO2 (in the order of 22 Ton/hr maximum) We are thinking to install a boiler (Natural gas fired to get CO2 from combustion...

I work for an Ammonia & Urea producing plant. We are interested to increase our actual capacity of the urea plant. We have an excess of NH3 but need an extra amount of CO2 (in the order of 22 Ton/hr) We are thinking to install a boiler (Natural gas fired, Off-gas optionally) to get CO2 from...

Thank you very much Spekuljak I will read your paper. Any other source for designing the facilities or Engineering Vendors ?

I work in a NH3 and urea producing plant. We a a very important quantity of effluent water that is normally contaminated with ammonia and carbamate that exceeds the ammonia regulations for the effluent of the plant. We do not have any effluent treatment plant. We only have several ponds to...