Recent content by 10031978

Hi Everyone, If, I run a steady state thermal analysis with loading condition as nodal temperature at specific points. Then will ansys calculate temperatures of other nodal points by LINEAR INTERPOLATION. If yes, then is there a way to make ANSYS calculate nodal temperatures by CUBIC OR...

Hi KalleH, I need your comments on this approach which was suggested by Kamlesh, FEM Analyst First, turn the model from structural to thermal (ETCHG). Apply temperature (DOF constraints) at 8 nodes of the cube. Run a static thermal analysis. Turn the model back from a thermal model to stl...

Hi KalleH, Can u provide any link or example to perform extrapolation using APDL loop. Thanks for the help. Regards, Izhar

Hi Everyone: I modelled a solid cube with 200-300 nodes. The loading condition is tricky. From experiments, I get thermocouple readings for 8 points in the cube for one cycle.Then, I inputted experimental temperatures at the same nodal location (for 8 nodes) in my model. My question is: How...