Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by 04kebuts
-
Plate Load Test question
So does this mean that the reading off the dial gauge on the jack is not the actual load that is being applied? So my first port of call will be to get the jack gauge calibrated. We have recently purchased a new jack (still using the old gauge) so I am glad I asked this question before it was...- 04kebuts
- Post #3
- Forum: Foundation engineering
-
Plate Load Test question
I have been given the task by my technical director to confirm that the spreadsheet we have been using to calculate the loading that we use for the plate load test is correct. We have both a 455mm plate and a 600mm plate. The dial gauge on the jack is in bar. I have tried - and failed - to...- 04kebuts
- Thread
- Replies: 4
- Forum: Foundation engineering
