Large surface files slowing computer down
Large surface files slowing computer down
(OP)
I use Unigraphics NX to design molds using complex surfaces. I develop problems when the models start to get large (10,000 plus surfaces) and my computer starts bogging down. Is there anyway I can make these files smaller and easier to work with? I am not concerned much with keeping the files parametric. I have tried exporting the models as a .prt and removing the parameters but sometimes this does not help. would it help to put large chunks of the model on seperate layers? Any ideas?





RE: Large surface files slowing computer down
"Wildfires are dangerous, hard to control, and economically catastrophic."
Ben Loosli
CAD/CAM System Analyst
Ingersoll-Rand