JOINED PART & MATES GOING BAD?
JOINED PART & MATES GOING BAD?
(OP)
When I create a joined part from an assy the mates associated with the assmbly that have been consumed by the new joined part now have invalid features to mate with. Do I just delete the bad mates, and if so will the joined part and assy update if the features/sketches are changed later?
Thanks in advance
TAP
Thanks in advance
TAP






RE: JOINED PART & MATES GOING BAD?
Regards,
Scott Baugh, CSWP
http://www.3dvisiontech.com
http://www.scottjbaugh.com
If you are in the SW Forum Check out the FAQ section
To make the Best of Eng-Tips Forums FAQ731-376