Missing .DLL
Missing .DLL
(OP)
Need help. I went to save a file as a JPEG but got the following message: "The specified module could not be found. Could not load Solidworks DLL: sldjpegu.dll". I figured that a file was corrupt so I did a repair on the software. All went well but I still get the error. I'm stumped; any tips?
SW '04 SP 3.0
WIN NT 4.0 SP 6.0
Thanks
SW '04 SP 3.0
WIN NT 4.0 SP 6.0
Thanks






RE: Missing .DLL
Regards,
Scott Baugh, CSWP
http://www.3dvisiontech.com
http://www.scottjbaugh.com
If you are in the SW Forum Check out the FAQ section
To make the Best of Eng-Tips Forums FAQ731-376
RE: Missing .DLL
You will hear it sooner or later, “Lose the Win NT 4.0”. SolidWorks 2005 Not supported
Supported Operating Systems
SolidWorks 2003 SolidWorks 2004 SolidWorks 2005
Windows XP Professional Windows XP Professional Windows XP Professional
Windows 2000 Professional Windows 2000 Professional Windows 2000 Professional
Windows NT 4.0 Windows NT 4.0 Not supported
Windows ME Windows ME Not supported
Windows 98 SE Not supported Not supported
Bradley
RE: Missing .DLL
RE: Missing .DLL
Regards,
Scott Baugh, CSWP
http://www.3dvisiontech.com
http://www.scottjbaugh.com
If you are in the SW Forum Check out the FAQ section
To make the Best of Eng-Tips Forums FAQ731-376
RE: Missing .DLL
RE: Missing .DLL
Regards,
Scott Baugh, CSWP
http://www.3dvisiontech.com
http://www.scottjbaugh.com
If you are in the SW Forum Check out the FAQ section
To make the Best of Eng-Tips Forums FAQ731-376