Verification on rebuild
Verification on rebuild
(OP)
it is a option which is off in default ...
if u active that .. rebuld time will increase about 2 or 3 times.. and rebuild process will done very acurately rather than "verification on rebuild " off.
in some casses u see no error on ur part , (specially on complex part) but when u on this option , u will see ooooh .. there are many errors .
if u active that .. rebuld time will increase about 2 or 3 times.. and rebuild process will done very acurately rather than "verification on rebuild " off.
in some casses u see no error on ur part , (specially on complex part) but when u on this option , u will see ooooh .. there are many errors .






RE: Verification on rebuild
Regards,
Scott Baugh, CSWP

http://www.3dvisiontech.com
http://www.scottjbaugh.com
FAQ731-376