Macro Help
Macro Help
(OP)
I want to select and edge and a face then run a macro.
What the macro will do is use the pre-selected face and create a sketch on it. It will then use the pre-selected edge as a axis of revolution to create a revolved cut.
I cannot figure out how to have the macro use the pre-selected entities in the macro.
Any help would be greatly appreciated.
Thanks
What the macro will do is use the pre-selected face and create a sketch on it. It will then use the pre-selected edge as a axis of revolution to create a revolved cut.
I cannot figure out how to have the macro use the pre-selected entities in the macro.
Any help would be greatly appreciated.
Thanks






RE: Macro Help
RE: Macro Help
Thanks in advance
RE: Macro Help
RE: Macro Help