Unhandled Errors
Unhandled Errors
(OP)
A couple of times a day, my Solidworks (2004) will shut down in the middle of a process and return an "unhandle error" fault. What does this mean? Is the anything I can do to prevent this (and losing work)?
Thanks - Dave
Thanks - Dave






RE: Unhandled Errors
Check out "Trouble Shooting a Crash prone System" - http://www.scottjbaugh.com/Tips_Tricks/Tips_Tricks.htm
You might try doing a repair or reinstall if the above tips don't help. FAQ559-908 FAQ559-488
Regards,
Scott Baugh, CSWP

http://www.3dvisiontech.com
http://www.scottjbaugh.com
FAQ731-376
RE: Unhandled Errors
John Richards Sr. Mech. Engr.
Rockwell Collins Flight Dynamics
There's no place like 127.0.0.1
RE: Unhandled Errors