A refrence for symbols on drawings
A refrence for symbols on drawings
(OP)
Howdy Ya'll,
I'm a inspector or a DOD subcontractor. I do ALOT of dimensional inspection(parts, components ect.) I'm @ a loss in interpeting the various symbols used on the drawings(meaning, I have never had that type of training)I was wondering if any-1 here would know of a on-line resource for these. ANY help would B GRATEFULLY APPRECIATED!!
TIA.!!
I'm a inspector or a DOD subcontractor. I do ALOT of dimensional inspection(parts, components ect.) I'm @ a loss in interpeting the various symbols used on the drawings(meaning, I have never had that type of training)I was wondering if any-1 here would know of a on-line resource for these. ANY help would B GRATEFULLY APPRECIATED!!
TIA.!!





RE: A refrence for symbols on drawings
ASME Y14.5M-1994 for Dimensioning and Tolerancing
Bradley
RE: A refrence for symbols on drawings
I am not trying to be mean, but if you intend to succeed in this job, I would suggest getting some schooling.
Ray Havermahl
Independent Engineering Labs
www.ielinc.com
RE: A refrence for symbols on drawings
RE: A refrence for symbols on drawings
@ testy.. My tenure has been 99% in the Electronics Manufacturing sector. I have recently accepted my present position. In the past.. Employers & peer's as well, have allway's considerd me to be a fairly bright chap. I just need a guide, as to the meanings of the symbols. If I come across something "over my head", I have access to the engineering department. Again.. Thank Ya'll for your input!