Revision Table Help
Revision Table Help
(OP)
I have created a Revision table template to meet our company standards. I am trying to use it for a 4 sheet drawing. I have inserted it on the first page and it looks right. Now when I try and insert it on the second, third or fourth page, it wont use the same template. It uses one without a title and the first two revisions say 'See Sheet 1". Has anyone else encountered this problem?
Sean Nutley
Carmanah Design and Manufacturing
Vancouver, BC, Canada
www.carmanahdesign.com






RE: Revision Table Help
You may want to look at Thread559-93136. Solidworks is setup to only put a revision table on the first sheet and all revisions are listed there. Revision tables on the other pages then point to the first sheet. I'm looking to request this as an enhancement.
mncad
RE: Revision Table Help
Sean Nutley
Carmanah Design and Manufacturing
Vancouver, BC, Canada
www.carmanahdesign.com
RE: Revision Table Help
Sorry bout that... gave you the wrong thread. It should have been Thread559-91293.
mncad