sheet metal layout for a box
sheet metal layout for a box
(OP)
is it possible to bend up two adjacent sides of a sheet metal box using a press brake and have them meet at the corner?
INTELLIGENT WORK FORUMS
FOR ENGINEERING PROFESSIONALS Come Join Us!Are you an
Engineering professional? Join Eng-Tips Forums!
*Eng-Tips's functionality depends on members receiving e-mail. By joining you are opting in to receive e-mail. Posting GuidelinesJobs |
sheet metal layout for a box
|
RE: sheet metal layout for a box
A cheat is to fold out the corners and reposition them when you are finished. Brake at the end of the dies so you only have two corners to reform.
Make sense?