Hole Wizard
Hole Wizard
(OP)
Is there a way to add information to the Hole Wizard?
I am looking at using a ANSI Metric tap M18x2.5. The hole wizard only lists the Metric Fine thread pitch (M18x1.5). I want to add this additional tap to the wizard list but I am hitting a wall in finding were to add the info.
I am looking at using a ANSI Metric tap M18x2.5. The hole wizard only lists the Metric Fine thread pitch (M18x1.5). I want to add this additional tap to the wizard list but I am hitting a wall in finding were to add the info.
Take care & have fun!
Kevin
"Hell, there are no rules here -- we're trying to accomplish something." - Thomas A. Edison






RE: Hole Wizard
Also check
Thread559-88481
Thread559-85994
Thread559-63157