Surfaces
Surfaces
(OP)
When doing a 'Delete and 'fill' command, why do other surfaces disappear? If I hover the mouse over the area where the surfaces have disappeared, the outline shows up, but as soon as I move the mouse off the surface, it goes again. I have tried rebooting. If I delete the 'Delete and fill' command and repeat it, there is a 50-50 chance of it curing itself.
Is there some setting which I am upsetting?
Any help will be wonderfull!!!!
Paul.
Is there some setting which I am upsetting?
Any help will be wonderfull!!!!
Paul.






RE: Surfaces
Good Luck
RE: Surfaces
Regards,
Scott Baugh, CSWP

http://www.3dvisiontech.com
http://www.scottjbaugh.com
FAQ731-376