AutoCAD 2004
AutoCAD 2004
(OP)
Help! I am on a tight schedule to get my Patented prototype heatsink ready for production. I am trying to fit more heat fins on the heatsink. Right now I have only 52 fins, I need 96+. The fin patterns are in a circular pattern on a square block. I cant get autoCAD to segment the concentric circle pattern more than 4 times. I need to segmet the circular pattern 8 times. The circles lie within the square box so it makes it very difficult to surther segment the circles. Any suggestions?





RE: AutoCAD 2004
Are you simply using the linetype Hidden? If so, change LTSCALE to a smaller number.
RE: AutoCAD 2004
45 degrees trim the circles
and then array the pattern?
RE: AutoCAD 2004
What's your fin thickness and circle diameter?