Gerotor
Gerotor
(OP)
How does one design a gerotor with Solidworks?
I have one in Autocad and tried to copy and paste it into a sketch, but Solidworks will not accept it. It was generated from a program so possibly it does not contain valid lines or curves.
Also, what do you use to design gear teeth? I have a program that was written for Autocad so the same problem might occur.
Thanks
I have one in Autocad and tried to copy and paste it into a sketch, but Solidworks will not accept it. It was generated from a program so possibly it does not contain valid lines or curves.
Also, what do you use to design gear teeth? I have a program that was written for Autocad so the same problem might occur.
Thanks






RE: Gerotor
Mirekp
Mechanical and engineering calculations
http://www.mitcalc.com
RE: Gerotor