BOM question
BOM question
(OP)
HI EVERYBODY!
I have a problem with BOM creation. The Catia does not assign identify number(Number) to sub-assembley if I create a BOM. There are numbers for each part but there are not for sub-assembley. Certeanly there will not be balloon for sub-assembley.
How can I solve this problem.
Thanky you the answer in advance.
I have a problem with BOM creation. The Catia does not assign identify number(Number) to sub-assembley if I create a BOM. There are numbers for each part but there are not for sub-assembley. Certeanly there will not be balloon for sub-assembley.
How can I solve this problem.
Thanky you the answer in advance.





RE: BOM question
One way to get around this is to name everything in the product structure tree and then bubble each part or assembly on the face of the drawing to the corresponding part or sub assembly number.
RE: BOM question