Control system clearances
Control system clearances
(OP)
Does anybody know of regulatory or guidance info as to what constitutes an "acceptable" clearance between control system members & adjacent items?
All regs say their must be adequate clearances & obviously they must be assesed over full range of ambient conditions.
I suspect that major design organisations have "in house" absolute minimum figuures, can anybody shine any light on these?
Thank you from little New Zealand, "down under".
All regs say their must be adequate clearances & obviously they must be assesed over full range of ambient conditions.
I suspect that major design organisations have "in house" absolute minimum figuures, can anybody shine any light on these?
Thank you from little New Zealand, "down under".
Graham Murphy





RE: Control system clearances
RE: Control system clearances